Bond between FRP composites and concrete: Assessment of design procedures and analytical models

The use of fibre reinforced polymers (FRPs) to strengthen reinforced concrete (RC) structures has gained a wide popularity in the last decades. Although many experimental and analytical studies are available in literature, some issues are still under discussion in the research communities. Since the typical failure mode of FRP–concrete joints is reported to be debonding of the composite from the concrete substrate [1], the estimation of the bond strength between FRP and concrete substrate represents a key issue for the proper use of this technology. For this reason, several analytical models for the evaluation of the FRP–concrete bond strength and few models for the estimation of the effective bond length were pro- posed (some of them are included in design codes/recommendations/guidelines); however they were not assessed by means of an appropriate experimental database. This work shows an assessment of twenty analytical models for the evaluation of the FRP–concrete bond strength. The assessment is based on the analysis of a wide experimental database collected from the literature. The results are provided distinguishing between the test setup adopted (single or double shear test, bending test) and the material used (post impregnated sheets or pre impregnated laminates). The accuracy of each model was evaluated by means of a simplified statistical analysis. The influence of the test setup and basic material on the accuracy of the model used was analysed as well. Lastly, the accu- racy of twelve available models in providing an estimation of the effective bond length was also assessed.