Are two better than one? A new approach for multidentate grafting of peptides to a gold substrate

Multidentate binding of two helical hexapeptides to a gold surface was obtained by introducing in the peptide chain a non ribosomial amino acid, i.e. the 4-amino-1,2-dithiolane-4-carboxylic acid (Adt) residue, a C-alpha-tetrasubstituted alpha-amino acid bearing a heterocyclic side chain characterized by a disulfide group. The two peptides, mainly formed by strongly helicogenic C-alpha-tetrasubstituted alpha-amino acids, were both functionalized at the N-terminus by a ferrocenoyl (Fc) group, but differ in the number of Adt residues included in the peptide chain: the former (Fc6Adt2) contains two Adt residues at positions 1 and 4, while its analog (Fc6Adt1) contains a single Adt at position 4, since the Adt at position 1 is substituted by an alpha-amino isobutyric acid (Aib) residue. This peptide design allowed us to explore the different electrochemical properties and morphologies shown by the two peptide layers immobilized on a gold surface by two (Fc6Adt2) or a single (Fc6Adt1) bidentate linker, respectively. The electrochemical activity of the ferrocenoyl probe embedded in the peptide film was characterized by cyclic voltammetry, chronoamperometry and square wave voltammetry, while the binding and the morphology of the peptide layers were studied by X-ray photoelectron spectroscopy (XPS) and ultra high vacuum scanning tunneling microscopy (UHV-STM), respectively. Significant differences were observed in the electron transfer (ET) properties of the two peptides investigated, which emerge from the diverging morphology achieved by the peptide layers on the gold surface. It was found that while a standing-up configuration of the peptide layer, realized by a single bidentate linkage, maximizes the ET efficiency, a lying down configuration (two Adt linkages) allows for precise positioning of Fc in the proximity of a gold surface.