Deposition areas: An effective solution for the reduction of the sediment volume transported by stony debris flows on the high-sloping reach of channels incising fans and debris cones

The main approach to managing the volume of sediment transported by stony debris flows routing along channels is through retention basins and open check dams, usually built in the lower reach just upstream of inhabited areas where slopes are gentler. In some cases, these measures are not sufficient to retain all the volume of sediment transported by debris flows. Works for trapping the sediments should also be placed in the upper reach of debris-flow channels. In this area, where the channel bed is characterized by very high slopes and vertical variability over time, constructing and maintaining transversal embankments for sediment retention is difficult. In addition, they could also be susceptible to failure, potentially increasing the magnitude of the phenomenon instead of mitigating it. On the other hand, other types of works, such as solid-body check dams or net barriers, have a decreasing efficiency over time in reducing the volume of sediment transported by debris flows. An alternative solution could be a retention basin open on the downstream side, that is, without the ending transversal embankment or berm. Therefore, it can be designated as a deposition area because the retention effect of the downstream embankment is missing, and sediment deposition only occurs due to the flatness of the basin. For sizing purposes, here, we derive two relationships between the deposition area and the volume of the deposit. These two relationships are derived from a physically based geometrical approach and empirical approach, respectively. After analyzing the morphology of the depositional processes that occurred in an existing deposition area during debris-flow events, we test the validity of the two relationships. Overall, these can be used independently or in combination for designing a deposition area. At last, we introduce the necessary geomorphological conditions for the construction of the deposition area and guidance for its placement.Deposition areas are retention basins without a dyke on the downstream side, which are placed in the high-sloping reaches of the debris-flow channels. In the present work, we propose two relationships, the former derived by a physically based geometrical approach and the latter from an empirical approach, for the sizing of a deposition area. Both the relationships are successfully tested against data of sediment deposits occurred during debris-flow events on the existing deposition area of Rovina di Cancia (Dolomites, northeast Italy).