Analysis of the HASI accelerometers data measured during the impact phase of the Huygens probe on the surface of Titan by means of a simulation with a finite-element model

In the analysis of Huygens mission data some unexpected features were present in the ACC data sets, so a dedicated study was needed to investigate the presence of dynamic interferences during an acquisition and correct the impact signature. The developed method is based on dynamic analysis of the impact through a three-dimensional finite-element dynamic model of the Huygens probe and the results lead to a corrected interpretation of accelerometer readings and provided an improved description of key aspects of the planetary landing. Although some aspects of probe’s state after impact need some further analysis, as for final resting attitude which is to date not completely agreed on, this study disclosed that the probe experienced a vertical decelerating action which is compatible with two possible scenarios: the first one implies the penetration in a soft substrate material followed by a lateral bounce out of the generated hole and the second one suggests the displacement of pebbles from the surface into the soil. Numerical elaboration of impact data calculated a 12 cm penetration into the surface, which may have been experienced either by the lower dome of the probe or from pebbles that were situated under the dome when contacting the planet. In either case after a few seconds of motion the Huygens probe finally rested above Titan’s surface with a negligible penetration. Since HASI piezo-accelerometer design was driven by the need of high full-scale values to monitor critical events during entry and descent phase, it was not possible to reconstruct horizontal motion after main deceleration phase without consistent uncertainties due to the poor overall accuracy in a low-acceleration range.